Sentera Controls RDCZ Series, Монтаж и эксплуатация

Страница: 6 / 12

www.sentera.eu
MIW-RDCZ-EN-003 - 29 / 10 / 2020 6 - 12
back to the table of contents
MOUNTING INSTRUCTIONS IN STEPS
Before you start mounting the unit read carefully “Safety and Precautions” .
Then proceed with the following steps:
For inset mounting
1. Disconnect the power supply.
2. Remove the frame cover of the enclosure and take the RDCZ controller out, so
that it can be easily connected.
3. Do the wiring according to the wiring diagram (see Fig. 1 ).
Fig. 1 Wiring and connections
L N
A /B
Power supply
110—230 VAC ±10%
50—60 Hz
Modbus
RTU
/B
A
Single phase AC Motor
Max 1,5 A
4. Mount the internal enclosure into the wall by inserting suitable connecting
elements into the openings. Mind the correct position and mounting dimensions
shown in
Fig. 2
and
Fig. 3
.
Fig. 2 Mounting dimensions - inset mounting Fig. 3 Mounting position
10
58
58
76
38
52
Correct Incorrect
5.
Put back the frame cover of the enclosure.
6. Switch on the power supply.
7. Customise the factory settings to the desired ones via the 3-button interface,
the 3SModbus software or via the Sensistant.
For surface mounting
1. Disconnect the power supply.
2. Remove the frame cover of the enclosure.
3. Take out the internal enclosure.
4. Mount the external enclosure to the wall using the delivered dowels and screws.
Mind the correct position and mounting dimensions shown in
Fig. 4
and
Fig. 4
.
RDCZ
RESIDENTIAL FAN SPEED
CONTROLLER