Sentera Controls DXTP, Монтаж и эксплуатация

Страница: 6 / 10

www.sentera.eu
MIW-DXTP-EN-000 - 29 / 09 / 2015 6 - 10
back to the table of contents
MOUNTING & OPERATING INSTRUCTIONS IN STEPS
Before you start mounting the DXTP controller read carefully “Safety and
Precautions”. Then proceed with the following mounting steps:
1.
Open the cover and insert the connecting cables through the cable gland of
the unit.
2. Do the wiring according to the wiring diagram (see Fig. 1 ) using the information
from section “ Wiring and connections ”.
Fig. 1 Wiring and connections
Power supply
15—24 VAC ± 10% / 18—34 VDC
Analogue output
0—10 VDC / 0—20 mA
Relay 1 contacts
Normally open
Common
Normally closed
Modbus RTU
/B A
3. Adjust the following settings:
3.1 Select the analogue output mode by JP4. (See Fig. 2 Analogue output
selection jumper. )
3.2 To reset the Modbus settings, put and hold jumper P1 for 20 seconds. (see
Fig. 3 Modbus reset jumper )
Fig. 2 Analogue output selection jumper Fig. 3 Modbus reset jumper
0—10 VDC 0—20 mA
5 4 3 2 1
Put and hold for 20
seconds
DXTP
DUCT TEMPERATURE CONTROLLER
WITH PI CONTROL