Install
1
Wireless MicroRadar
TM
Sensor Installation Quick Start Guide:
VSN
240
-M
Ensure sensor label is visible
and record sensor number.
Sensor in Shell
Installation
Core hole 4” diameter,
2 1/2” depth.
Core
Vacuum or brush hole clear of
debris. Ensure hole is dry.
Clear Debris from Hole
Fill EMPTY HOLE half way with
epoxy.
Apply Epoxy
Ensure sensor is 1/4” or less
below surface, level, label up, and
arrow points in direction of traffic.
Place Sensor
Fill hole with epoxy. Level to
road surface.
Apply Epoxy
Allow 5 - 10 minutes to cure.
Installed Sensor
Removal, see reverse side
Trim the sensor shell legs to
level as needed. Ensure that
the sensor and shell reach the
required height of 1/4” or less
below road surface.
Trim Shell Legs
See Important Safety Warnings on
Opposite Side
