SENSTAR MPS-4100, Руководство по эксплуатации продукта

Страница: 29 / 70

Relay output wiring
MPS-4100 product guide • • • 2 - 15
detected. The slow setting will reliably detect a typical human sized target moving
between 5 cm (2 in.) per second and 13.4 m (44 ft.) per second. The fast setting
will reliably detect targets moving between 25 cm (10 in.) per second and 61 m
(200 ft.) per second. The fast setting is used for detecting vehicles.
The target speed is set via JP7 on the Receiver PCB. Figure 2-11 illustrates the
shunt settings; and Figure 2-10 indicates the location of JP7 on the receiver PCB.
• Place a shunt on pins 1 and 2 of JP7 for the fast target setting.
• Place a shunt on pins 2 and 3 of JP7 for the slow target setting.
Receiver DIP-switch functions
Figure 2-11 JP7 target speed settings
DIP-switch S1 Function DIP-switch S2 Function
S1-1
ON for network operation
OFF for relay output (standard mode)
S2-1
ON enables audio O/P via TB3
OFF enables audio O/P via TB1
S1-2
ON enables self-test (standard mode)
OFF for network operation
S2-2 Not used
S1-3
ON for network operation
OFF for relay output (standard mode)
S2-3
ON connects Tamper to network O/P
OFF for standard Tamper O/P
S1-4
ON enables self-test (standard mode)
OFF for network operation
S2-4
ON enables alignment aid LEDs
OFF disables alignment aid LEDs
S1-5
ON enables alarm O/P on jam
OFF disables alarm O/P on jam
S2-5
ON enables alarm relay reset
OFF latches alarm relay
S1-6
ON connects Tamper to network O/P
OFF for standard Tamper O/P
S2-6
ON enables alarm relay
OFF disables alarm relay
Table 2-4 Receiver DIP-switch functions
JP7
FAST SLOW fast target setting slow target setting