Fence structures
Senstar LM100 Product Guide
Page 17
Climb-over deterrent hardware
Barbed wire
Barbed wire outriggers must be secure to prevent movement due to environmental conditions.
Each barbed wire strand should be taut and tightly secured at each support. Any extension arms
or outriggers attached to post tops should have a tight press-fit or be spot-welded. Fasten and
secure any loose components.
Razor ribbon
The razor ribbon must be secured so that it does not move in the wind. Use bracing wires to
secure the coil and to prevent the razor ribbon from separating if it is cut.
Note
The mounting height of the Senstar LM100 luminaires on the fence
posts may require adjustment to avoid contact with the climb-over
deterrent hardware.
Figure 7: Avoiding contact with barbed wire
Figure 8: Razor ribbon
to avoid contact with the barbed wire
lower the luminaires mounting height
razor ribbon
bracing wire
wire tie
