Cable installation on different fence types
Intelli-FLEX II product guide • • • 5 - 11
•
For sensor cable that is attached to the same side of the fence as the
horizontal wires, the sensor cable should be placed directly below the
horizontal wire and tie wrapped every 25 cm (10 in.) along the fence.
•
For sensor cable that is attached to the opposite side of the fence - the vertical
fence wires are on the same side as the sensor cable - the tie wraps should be
placed at the intersection points of the weld-mesh wires every 25 cm (10 in.).
On Palisade fence
Keep the following in mind when installing Intelli-FLEX sensor cable on a
Palisade-style of fence:
•
Along the flat sections of fence, insert the sensor cable in plastic strips or clips
and fasten the strips to the upper horizontal fence support using tie wraps.
•
Leave the cable exposed at the support pillars so that it can curve smoothly
around the pillar and maintain maximum contact with the fence.
•
On palisade fences greater than 2.0 meters in height, deploy the sensor cable
in a square wave pattern with the top and bottom sections attached to the
upper and middle support, respectively.
•
Unlike chain-link or weld-mesh fences, palisade fences have a uniform
construction along the entire fence line including the corners. Therefore, no
special sensor cable deployment is required at corners.
Figure 5-12 Palisade fence
