PPD Maintenance Manual
T1DA0502-002, Rev A
Page 17
Figure 6.2.2 Man-Down Module Programming Dialog
6.2.3 Program
Module
When all parameters have been set, select the Program Module button. If there are no errors, a
pop-up will inform you of programming success. If desired you can select Get Info to read the
parameters from the MDM. Select Done to close the Man-Down programming dialog and return
to the Transmitter Programmer Main Screen. Perform the after programming steps outlined in
section 4.7.
6.2.4 Get
Info
It is sometimes useful to determine how a particular man-down module has been programmed.
The Get Info function allows you to read the settings from the unit (Figure 6.2.4).