Sensia QRATE Scanner 3300, Инструкция по установке, эксплуатации и обслуживанию

Страница: 71 / 92

A (“topmost”)
B C
D E
Parameters configured
as “topmost” will always be
displayed in the “A” position
Parameters not configured
as “topmost” will scroll through
the four fields in the bottom half
Figure 4.3 - Arrangement of parameters in Touch screen display
Web Interface Kiosk Mode
Using the touch display, a user can navigate to the Web Interface and configure the QRATE Scanner 3300. It is recom -
mended to complete installation before proceeding with the configuration.
Note Only users with Administrator or Configuration Editor user access levels can change display features. See the
QRATE Scanner 3300 Web Interface User Manual for instructions on setting user security levels.
Important When the device has been successfully setup with an Ethernet connection, you can configure the
wireless network.
Important The QRATE Scanner 3300 web interface requires JavaScript to be enabled. For instructions about
enabling JavaScript in the 5 most commonly used web browsers, see http://www.enable-javascript.
com/
.
IP Address Options
The QRATE Scanner 3300 accommodates both dynamic and static IP addresses.
Dynamic IP is considered the least restrictive means of supporting communications with the Scanner, and is often pre
-
ferred by corporations with extensive IP needs. However, you should be aware that dynamic IP addresses are subject to
change over time (the frequency of such changes is controlled by corporate network settings).
Static IP addresses are unchanging, which helps protect user access to the device but restricts the address from being
used with any other device. A static IP address may be a consideration if you must access the device from a great dis -
tance and do not have a local contact near the device who can verify the IP address from the device display.
Note Static IP addresses can be disabled during firmware upgrades, requiring onsite assistance to restore the static IP
address.
Dynamic IP is recommended for initial setup of the device. Once communication with the device is achieved, a static IP
address can be assigned, if applicable. Basic instructions for changing an IP address are provided in the QRATE Scanner
3300 Web Interface User Manual linked to the web interface. Step-by-step instructions may vary with web utilities and
computer operating systems. If you are unfamiliar with this process, seek assistance from an IT professional.
Important The following instructions will help guide you through an initial connection to the QRATE Scanner
3300 using the Scanner’s dynamic IP address. If a static IP address is required for ongoing Scan
-
ner communications, the IP can be reconfigured in the web interface after this initial connection.
See the static IP configuration instructions in the QRATE Scanner 3300 Web Interface User Manual
for details.
65
QRATE Scanner 3300 integrated control flow computer Section 4