ORB-X1 Quick Start Guide
ORB-X1
Mounting brackets
Mounting screws
Gland inserts
Allen key
1. What is in the Box?
If using GSM and the
ORB does not contain
an internal SIM, insert
a SIM card, note the
orientation carefully.
3. Insert SIM Card
Apply power to
pin 1 and ground
to pin 2 of the
header or insert 4
x AA batteries.
The green light
will go on and
orange light will
flash.
4. Apply Power
5. Enter Setup Mode
Press the
setup
button to enter
setup mode and
activate the ORB
webserver. The
green light will
flash.
Use a phone or tablet to connect
to the ORB’s Wi-Fi using the SSID
and Wi-FI password located
under the lid.
Using a web-browser, go to
192.168.4.1. Enter username
“admin” and the ORB’s setup
password to access the ORB’s
webserver.
6. Connect to the Webserver
Configure Wi-Fi or
GSM connectivity
using the Network
tab. Save settings.
If using GSM, set
the correct APN for
your SIM.
Close the lid to exit
setup mode.
7. Configure the ORB
Create an
account on the
Senquip Portal
(portal.senquip.
com) to view
data and
configure your
ORB.
8. Access your Data
Using the 3mm Allen
key provided, loosen
the 6 cover screws
ensuring that all 6
screws have ejected
before opening.
2. Open the ORB
7. LED Status Guide
The image on left shows the
ORB brackets in the wall
mount position; to pole
mount rotate the brackets
by 180 degrees. To wall
mount, remove the brackets
and screw directly into the
ORB mount points.
8. Mounting the ORB
STATUS
NETWORK
Meaning
Off
Off
Device is sleeping
Flash (1Hz)
Off
Setup Mode
On
Flash (1Hz)
No internet connection
On
On
Internet connection
Fast Flash
Fast Flash
Factory Reset
Off
Fast Flash
Firmware Update
Slow Flash
Off
Pre-charge mode
