Using the transmitter
13
Using the transmitter
To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see below).
2. Switch the EK 2000 IEM receiver on (see the instruction manual of the receiver).
The transmission link is established.
If you cannot establish a transmission link between transmitter and receiver:
왘
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
왘
If necessary, read the chapter “If a problem occurs ...” on page 24.
Switching the transmitter on/off
To switch the transmitter
on
(online operation):
To switch the transmitter to
standby mode
:
왘
If necessary, deactivate the lock mode (see page 14)
To switch the transmitter on and to
deactivate the RF signal on switch-on
(offline operation):
To completely switch the transmitter
off
:
왘
Disconnect the transmitter from the mains by unplugging the mains plug from the wall
socket.
The backlighting of the
STANDBY
button
goes off.
It is vital to observe the notes on frequency selection on page 22.
0**
왘
Briefly press the
STANDBY
button
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
is displayed.
왘
Keep the
STANDBY
pressed until “
OFF
” appears on the display panel.
The display panel switches off.
When in the operating menu, pressing the
STANDBY
button
will cancel your entry
(ESC function) and return you to the standard display.
The
STANDBY
button
is backlit in red both during operation and in standby mode.
왘
Press the
STANDBY
button
until “
RF Mute On?
” appears on the display panel.
왘
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit an
RF signal. The transmission icon
is not displayed.
Standard -18dB
MHz
PEAK
-10
0
-20
-30
-40
PEAK
-10
0
-20
-30
-40
AF II
AF I
**2000**
552.300
B.Ch: 5.14
EQ
!
