Putting the transmitter into operation
12
Connecting devices to the output sockets
왘
Use a suitable cable to connect the audio input of a device (e.g. a mixing console or an
additional SR 2000 IEM or SR 2050 IEM) to the output socket
LOOP OUT BAL L(I)
and/
or
LOOP OUT BAL R(II)
(see preceding chapter).
Connecting transmitters in a network
You can connect several transmitters in a network. The transmitters are remote controlled via
a PC running the “
Wireless Systems Manager
” (WSM) software. This software will assist in
the quick and safe configuration of multi-channel systems.
왘
Connect a standard network cable (at least Cat 5) to the LAN socket
of the transmitter.
왘
Connect your transmitters to an Ethernet switch.
왘
Connect a PC to the Ethernet switch.
When a transmitter is properly connected to the Ethernet switch or the PC, the yellow
LED
at the rear of the transmitter lights up.
For further information on network operation, refer to page 22.
Connecting the mains cable
왘
Pass the mains cable through the cable grip
왘
Connect the mains cable to the mains socket
왘
Plug the mains plug into the wall socket.
ETHERNET RJ-45
B
RF OUT
ANT B
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 627945
SER NO 251810043
FMO
IC 2099A-SR20x0
Stereo Transmitter SR 2000 IEM
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 503841
SER NO 2518100095
FMO
IC 2099A-SR20x0
L(I)
R(II)
+22dBu
MAX
Loop Out A
BAL
The signal received from the AF input sockets
BAL AF IN L(I)
and
BAL AF IN R(II)
is actively buffered and then routed to the output sockets
LOOP OUT BAL L(I)
and
LOOP OUT BAL R(II)
. The AF output sockets will therefore work only when the trans-
mitter is switched on and powered.
The “
Wireless Systems Manager
” (WSM) software can be downloaded from the
corresponding product page on our website at www.sennheiser.com.
ETHERNET RJ-45
RF OUT
ANT B
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 627945
SER NO 251810043
FMO
IC 2099A-SR20x0
Stereo Transmitter SR 2000 IEM
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 503841
SER NO 2518100095
FMO
IC 2099A-SR20x0
L(I)
R(II)
+22dBu
MAX
Loop Out A
BAL
CAUTION!
Damage due to electric current!
If you connect the transmitter to an unsuitable power supply, this can cause damage to the
device.
왘
Use the supplied mains cable to connect the transmitter to the mains (100 to 240 V AC,
50 or 60 Hz).
왘
Ensure a reliable mains ground connection of the transmitter – especially when you are
using multi-outlet power strips or extension cables.
50/60Hz 0.2 A
ETHERNET RJ-45
B
100 - 240V
