Sennheiser SKP 300 evolution wireless G3, Инструкция по эксплуатации

Страница: 11 / 34

10 | SKP 300 G3
Using the plug-on transmitter
Using the plug-on transmitter
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see the receiver’s instruction
manual).
2. Switch the plug-on transmitter on (see next
section).
The transmission link is established and the
receiver’s RF level display “
RF ” reacts.
If you cannot establish a transmission link between
plug-on transmitter and receiver, read the chapter
“Synchronizing the plug-on transmitter with a receiver”
on page 23.
Switching the plug-on transmitter on/off
To switch the plug-on transmitter on (online operation):
To switch the plug-on transmitter on and to deactivate
the RF signal on switch-on (offline operation):
It is vital to observe the notes on frequency selec-
tion on page 23.
왘
Press the ON / OFF button
8
.
The plug-on transmitter transmits an RF
signal. The red
ON LED
7
lights up and the
“ Frequency/Name ” standard display appears
on the display panel. The transmission
icon
4
is displayed.
왘
Keep the ON / OFF button
8
pressed until “ RF
Mute Off? ” appears on the display panel.
왘
Press the UP/DOWN button.
“
RF Mute On? ” appears on the display panel.
왘
Press the SET button.
The transmission frequency is displayed but
the plug-on transmitter does not transmit an
RF signal. The transmission icon
4
is not
displayed.
7
8
ON/OFF
ON/OFF
SET
MHz 543.850
ew300 G3
MUTE
P
AF