Sennheiser SKM 9000, Инструкция по эксплуатации

Страница: 16 / 109

Digital 9000 | 15
Product overview
Overview of the rear panel
The overview of the rear panel shows an EM 9046 receiver equipped with the fixed PSU , CCC and ASP modules and the
optional DRX , DAO and AAO modules. The configuration shown is an example configuration. The interchangeable mod-
ules are highlighted in color.
Your Sennheiser service partner can configure the EM 9046 as follows:
• 1 to 8 EM 9046 DRX receiver modules
• 1 AAO analog audio out module and 1 DAO digital audio out module or
• 2 AAO analog audio out modules or
• 2 DAO digital audio out modules
H
D E
D
E
A B D C E F
G
H
I
I
4
G
H
3 1 2 A 0 C 5 E F
9 B D
I
J
8 7 6 K
1
ON / OFF switch
2
IEC mains socket, 3-pin
3
LAN UP socket
4
LAN DOWN socket
5
SERVICE interface
6
LAN UP LED
7
LAN DOWN LED
8
WORD CLOCK OUT socket (BNC),
looped-through output (75

)
9
WORD CLOCK IN socket (BNC), input (75

)
0
Blanking plate for aux opening
A
XLR-3 sockets (male) for digital audio outputs
1/2 to 7/8 , balanced, AES3
B
DIGITAL MUTLICORE socket (sub-D, 25-pin), digital, balanced
C
XLR-3 sockets (male) for analog audio outputs
1 to 8 , transformer balanced
D
ANALOG MULTICORE socket (sub-D, 25-pin),
analog, transformer balanced
E
RF IN A socket (N-type), antenna input,
12 V out, max. 200 mA, 50

F
RF IN B socket (N-type), antenna input,
12 V out, max. 200 mA, 50

G
RF OUT A socket (N-type), daisy chain output
H
RF OUT B socket (N-type), daisy chain output
I
EM 9046 type plate
J
DRX receiver modules 1 ... 8
K
Ventilation openings
A | PSU – power supply unit
B | CCC – clock core controller
C | Aux opening for optional extensions
D | DAO – digital audio out
E | AAO – analog audio out
F | ASP – antenna splitter
G | Type plate
H | DRX – receiver modules
I | Ventilation openings
For the pin assignment of the XLR-3 and sub-D sockets of the EM 9046, refer to the chapter “Specifications”
on page 106.