Sennheiser Set 830-TV, Инструкция по эксплуатации

Страница: 28 / 36

25
Additional technical information
Changing the operating mode
The transmitter can be set to a different operating mode. This is useful
when the sound of your sound source is very low and the transmitter
therefore does not always switch on automatically.
Particularities of operating mode 2:
In operating mode 2, the transmitter is not switched on by the sound
signal from the sound source.
To switch the transmitter on :
왘
Take the receiver out of the charging compartment.
To switch the transmitter off :
왘
Place the receiver into the charging compartment.
If – in operating mode 2 – you want to use a second receiver and charge
its rechargeable battery during operation:
왘
Press the “speech intelligibility” button
9
for approx. 5 seconds.
The indicator
0
goes off. The charging indi-
cator for the spare rechargeable battery
6
flashes several times:
red: operating mode 2
green: operating mode 1 (factory preset setting)
If the operating mode was changed success-
fully, the charging indicator for the spare
rechargeable battery
6
goes off and the
indicator
0
lights up again.
왘
Pull the battery out of the receiver’s battery
compartment
3
.
왘
Slide the battery into the transmitter’s
charging compartment
5
as far as it will go.
0
9
6
3
5