Sennheiser RS 4200 II -, Инструкция по эксплуатации

Страница: 16 / 23

Using the system components
12 | RS 4200 II
Adjusting the volume
If the transmitter is connected to a headphone socket of
your sound source:
왘
Adjust the volume of the sound source to a medium
level. This improves the quality of wireless sound
transmission.
왘
Use the volume control
1
to adjust the volume to a suf-
ficient and comfortable level.
Automatic transmitter search tuning
왘
Put the receiver on.
The receiver starts searching for a transmitter signal
and automatically tunes itself to the last selected
channel. If a transmitter signal is found, the transmitter
search tuning stops and the receiver produces –
depending on the selected channel – 1, 2 or 3 beeps (see
“Meaning of the LEDs and acoustic signals” on page 14).
The audio transmission then starts.
If the signal found is not the correct one (e.g. from another
nearby system):
왘
Briefly press the TUNE button
4
to continue the trans-
mitter search tuning.
Changing the transmission and receiver channel
If several transmitters are operated simultaneously and
are very close to one another, reception can be subject to
interference (e.g. hissing).
왘
Change the position of the channel selector switch
CHANNEL
6
to change the transmission channel.
왘
Press the TUNE button
4
to re-start transmitter search
tuning (see previous section).
Adjusting the balance
The RS 4200 II features a balance control for right/left
volume adjustment.
왘
Use the balance control
3
to adjust the volume so that
you hear equally well with both ears.
1
4
6
3