Sennheiser RS 4200 II -, Инструкция по эксплуатации

Страница: 14 / 23

Putting the system into operation
10 | RS 4200 II
Inserting and removing the receiver’s
rechargeable battery
The receiver is delivered with the battery inserted.
왘
Insert the battery into the compartment
2
as shown on
the left. Make sure that the battery is inserted correctly.
왘
To remove the battery, use the finger catch projection to
pull the battery out of the receiver.
왘
Before using the rechargeable battery for the first time,
charge it until the LED
C
lights up green (see “Storing
and charging the receiver” on page 13). This can take a
maximum of 3 hours.
Inserting a spare rechargeable battery into the
transmitter’s charging compartment
You can charge a spare battery (not included) in the
charging compartment
A
at the side of the transmitter.
This spare battery is not required for operating the
RS 4200 II but offers extended listening time while the dis-
charged first battery is being recharged.
왘
Insert the spare battery into the charging com-
partment
A
as shown on the left.
왘
If the battery is inserted correctly, the LED
B
lights up
Replacing the ear pads
The product is supplied with two pairs of ear pads in dif-
ferent fits. You can change to these ear pads to optimize
the wearing comfort, if necessary (see “Cleaning the ear
pads” on page 15).
2
A
B
red: The rechargeable battery is being charged.
green: The rechargeable battery is fully charged.