Sennheiser evolution wireless G3 EM 100, Инструкция по эксплуатации

Страница: 21 / 59

Using the receiver
20
To switch the receiver to standby mode :
To completely switch the receiver off :
왘
Disconnect the receiver from the mains by unplugging the mains unit
from the wall socket.
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 100 G3 series with
the receiver. During synchronization, the following parameters are trans-
ferred to the transmitter:
왘
Keep the STANDBY button pressed until “ OFF ” appears on
the display panel.
The receiver switches to standby mode.
When in the operating menu, pressing the STANDBY button will
cancel your entry (ESC function) and return you to the current stan-
dard display.
Setting Transferred parameters
“ Frequency Preset ” Currently set frequency
“ Name ” Freely selectable name currently set on the receiver
“ Pilot Tone ” Current pilot tone setting of the receiver
(“
Inactive ”/“ Active ”)
It is vital to observe the notes on frequency selection on page 42.