Sennheiser EM 3731-II - ANNEXE 583, Инструкция по эксплуатации

Страница: 41 / 50

Adjustment tips for the operating menu
40
Setting a receiver to standby mode
You can set a receiver to standby mode and mute it. To do so, proceed as
follows:
왘
Change to the setting mode of the “ Standby ” menu.
The icon and the green backlighting of the save button
8
flash.
왘
Press the save button
8
.
The esc button
6
is backlit in red. The receiver is set to standby mode
and the display is switched off.
To end the standby mode:
왘
Press the jog dial
7
or the esc button
6
.
The display is switched on.
Loading the factory-preset default settings
Via the “ Reset ” menu, you can reset the current settings to the factory-
preset default settings.
왘
Change to the setting mode of the “ Reset ” menu.
The query “ Reset to factory defaults? ” appears. The green backlighting
of the save button
8
flashes.
왘
Press the save button
8
until the progress bar is complete.
All settings except for the booster supply voltage, the sampling rate at
the digital output and the network address are reset to the factory-
preset default settings. The display changes to the selection mode of
the operating menu.
Standby
OFF
Rese
000
MAC
0 1B
6 00
0 01
OFF
esc
s ave
syn c
digital audio
processing
syn c
DEV
M
H
z
800.450
03.03 BANK
CH
COM AF
The standby mode remains active even when you switch the
receiver off and on again.
Reset
000
andby
OFF
000
Reset to
factory defaults ?
esc
s ave
syn c
digital audio
processing
syn c
DEV
M
H
z
776.000
01.01 BANK
CH
COM AF