Sennheiser EM 3731-II - ANNEXE 583, Инструкция по эксплуатации

Страница: 22 / 50

21
Using the receiver
To monitor the audio signal of one of the two receivers of a twin receiver:
왘
Press the headphone button
0
of the receiver whose audio signal you
want to monitor.
To simultaneously monitor the audio signals of both receivers of a twin
receiver:
왘
Simultaneously press the headphone buttons
0
of both receivers.
The audio signal of the left receiver is output via the left headphone
channel, the audio signal of the right receiver is output via the right
headphone channel.
왘
Gradually increase the volume.
To switch the headphone output off:
왘
Press the headphone button
0
of the receiver whose headphone
output you want to switch off.
Deactivating the lock mode
When the receivers are remote controlled via a PC and the “Wireless
Systems Manager” software, their buttons can be locked via the “Wireless
Systems Manager” software. To deactivate the lock mode:
왘
Press the esc button
6
until the progress bar is complete and the
status display appears.
The lock mode is deactivated and the settings can be made manually.
Synchronizing a transmitter with the receiver frequency
Via its infra-red interface, the receiver can transfer the frequency and the
name to suitable transmitters (e.g. SK 5212-II, SKM 5200-II, SK 5212,
SKM 5200 or SKP 3000).
왘
Set the receiver to the desired receiving frequency (see “Setting the
receiving frequency” on page 30, “Selecting a frequency bank and a
channel” on page 30) and enter the desired name (see “Entering a
name” on page 31).
왘
Press the sync button
9
.
The two blue LEDs in the infra-red interface (sync)
A
flash and the
backlighting of the sync button
9
flashes red. The receiver is ready for
synchronization.
esc
s ave
syn c
300
100
30
10
10
50
100
PEAK
µ V
RF % DEV
M
H
z
776.000
01.01 BANK
CH
A B
COM AF
0 6
Hold esc to unlock
The transmitter must be from a compatible frequency range and be
equipped with the same compander system (HDP, see page 42) as
the receiver.
esc
s ave
syn c
digital audio
processing
syn c
EV
M
H
z
776.000
01.01 BANK
CH
COM AF
9
A
The sync button
9
can also be used for the sorting function of the
“Wireless Systems Manager” software. For more information, refer
to page 23.