Sennheiser EM 100 G4, Инструкция по эксплуатации

Страница: 65 / 129

Using the EM 100 G4
64
Easy Setup menu item
You can scan for unused frequencies using the Easy Setup menu item.
When you have connected multiple EM 100 G4 devices to a network via the
RJ-10 interfaces (see “Creating a data network”), you can perform the fre-
quency setup for all of the connected receivers. You can find more informa-
tion about connecting multiple devices under “Performing multi-channel
frequency setup”
Switch off all transmitters before you perform the scan. If transmit-
ters are still switched on, they are detected as unavailable frequen-
cies and the frequencies that are actually available cannot then be
used.
The squelch threshold setting influences the result. Set the squelch thresh-
old to
Low for as many frequencies as possible, and to High for as many
safe frequencies as possible (see “Squelch menu item”).
To open the Easy Setup menu item:
▷ On the home screen, press the SET button to open the operating menu.
▷
Press the UP or DOWN button until the Easy Setup menu item appears
in the selection frame.
▷ Press the SET button to open the menu item.
Scan New List
▷ Select Scan New List to scan for unused frequencies.
▷ Press the SET button to start the scan.
The frequency range of the receiver is scanned. As a result, the number
of unused frequencies is displayed for every frequency bank.
▷ Press the UP or DOWN buttons to select a frequency bank.
▷ Press the SET button to confirm your selection.
▷ Press the UP or DOWN buttons to select an unused frequency from the
selected bank.