13
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on (see the instruction manual of the trans-
mitter).
The transmission link is established and the receiver’s RF level display
“
RF
”
reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing a transmitter with the diversity
receiver” on page 28.
Switching the diversity receiver on/off and adjusting
the volume
To switch the diversity receiver
on
:
왘
Turn the volume control
clockwise until it clicks.
The red
ON
LED
lights up. The “
Frequency/Name
” standard display
appears on the display panel.
To switch the diversity receiver
off
:
왘
Turn the volume control
counterclockwise until it clicks.
The red
ON
LED
goes off and the diversity receiver switches off.
It is vital to observe the notes on frequency selection on page 28.
쐏
���
