Sennheiser Digital 9000, Инструкция по эксплуатации, Страница: 84 / 130

Using the EM 9046
82 | Digital 9000
After synchronization with the transmitter, the value actually adopted by
the transmitter is written back to the menu item.
“Display” – Selecting the standard display for the transmitters
The “ Display ” menu item allows you to activate one out of 3 standard dis-
plays: “ Name ”, “ Preset ” or “ Frequency ”. The “ Name ” standard display is
factory preset.
“Lock” – Activating/deactivating the lock mode
Via the “ Lock ” menu item, you can activate or deactivate the lock mode for
your transmitters.
“AF source” – Displaying the audio source
The “ AF source ” menu item allows you to display the type of microphone
head being used (SKM), the type of audio source being used (SK: “ micro ”,
“ line ”) and the emulation of instrument cables (SK: “ type1 ”, “ type2 ”,
“ type3 ”). This information is transmitted along with the SKM/SK 9000’s
RF signal to the receiver.
The information is displayed until the transmitter is switched off or the
carrier frequency is changed. When the SKM/SK transmits again on the
carrier frequency, the corresponding microphone head/audio source is dis-
played once again in the menu item.
If a transmitter is switched off or transmits on a different carrier fre-
quency, “
No TX detected ” is displayed.
“Cable” – Emulating different instrument cable lengths
frequency
display
off
lock
SK 9000 line
af source
type1
cable