Using the EM 300-500 G4
81
Easy Setup menu item
You can scan for unused frequencies using the
Easy Setup
menu item.
When you have connected multiple EM 300-500 G4 devices to a network
via the RJ-45 interfaces (see “Creating a data network”), you can perform
the frequency setup for all of the connected receivers.
Switch off all transmitters before you perform the scan. If trans-
mitters are still switched on, they are detected as unavailable fre-
quencies and the frequencies that are actually available cannot
then be used.
To open the
Easy Setup
menu item:
▷
On the home screen, press the
jog dial
to open the operating menu.
▷
Turn the
jog dial
until the
Easy Setup
menu item appears in the selec-
tion frame.
▷
Press the
jog dial
to open the menu.
Scan New List
►
▷
Select
Scan New List
to scan for unused frequencies.
▷
Press the
jog dial
to start the scan.
The frequency range of the receiver is scanned. As a result, the number
of unused frequencies is displayed for every frequency bank.
▷
Turn the
jog dial
to select a frequency bank.
▷
Press the
jog dial
to confirm your selection.
▷
Turn the
jog dial
to select an unused frequency from the selected bank.
▷
Press the
jog dial
to save your selection and synchronize the selected
frequency with the transmitter at a later point (see “Synchronizing de-
vices”).
or
