Sennetech SCT-1041, Руководство пользователя

Страница: 6 / 10

6
REAR PANEL
Power
input
Diamond
RS-422 outputs
The output baud rate is 9600.
Connect to the Diamond receiver
data + and data- lines
S = shield (optional)
FRONT PANEL
Vicon
receive
indicator
Flashes when there
is input data
Diamond
transmit
indicator
Flashes continu-
ously while sending
Diamond data
Power
indicator
The Rx indicator will flash whenever there is data from the Vicon controller. If the input lines have
reversed polarity, the Rx indicator will be on solidly. Diamond data is repeating, so the Tx indicator
will continue to flash while the camera is moving.
If you have Rx but no Tx, possible causes are:
The Vicon code sent to the translator is not camera control code.
The camera address is outside the address window set by the configuration switches.
If the code translator is sending data and does not get a follow-up Vicon command in about 12
seconds, it will time out and quit sending that stream of data.
Vicon
Data input
Connect to the cmd data
lines from the Vicon
controller
Vicon
Rsp output
Connect to the response
data lines from the Vicon
controller (if needed)
INSTALLATION
DIAMOND DATA OUTPUTS VICON
CMD IN
RSP OUT
POWER
9V to 15V
AC or DC
S S S S
S S
VICON
Power Tx Rx
CODE TRANSLATOR