User Manual
Z-SG2 / Z-SG2-L
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
www.seneca.it
Doc: MI-005370-EN
Rev. 1.0.0.2
Page 31
Field or Manual.
FACTORY CALIBRATION WITH TARE ACQUISITION FROM THE FIELD
In the tare acquisition mode from the field, proceed as follows for calibration:
1)
Replace the tare on the cell
2)
Wait for the measurement to stabilize
3)
Press the "TARE ACQUISITION (FLASH)" button
FACTORY CALIBRATION WITH MANUAL TARE ACQUISITION
It is not always possible to acquire the tare value from the field (for example in the case of already filled silos),
in these cases it is possible to introduce the tare weight in technical units:
