Seneca Z-KEY, Руководство по установке

Страница: 2 / 8

MI00369-3-EN ENGLISH2/8
1 PRELIMINARY WARNINGS
The full content of this manual must be read before performing any operation. The module
must only be used by qualified electricians. Specific documentation is available at
www.seneca.it
The module must be repaired and damaged parts replaced by the Manufacturer. The product
is sensitive to electrostatic discharges. Take appropriate measures during any operation.
The warranty is null and void in the event the module or devices supplied by the
Manufacturer, necessary for correct operations, are improperly used or tampered with and, in
any case, if the instructions contained in this manual were not followed.
2 PRELIMINARY USE INSTRUCTIONS
Obstructing ventilation slots with any object is prohibited.
Installing the module next to devices that generate heat is prohibited.
3 GENERAL SPECIFICATIONS
CPU ARM 32 bit
Possibility of configuration via Web-server.
Micro SD card slot, Max 32 GB (Optional) for custom webserver and FTP server pages.
One Ethernet 100 Mbits/s port
One RS485 port.
One RS485/RS232 commutable port.
One USB port.
1500 V

power insulation with respect to the remaining low voltage circuits.
Facilitated power and serial line cabling via Seneca bus that can be housed in the IEC EN 60715 omega
guide.
Pull-out terminals, section 2.5 mm
2
.
Power indication, RS485/RS232 Rx and Tx, ETHERNET connection and activity on SD card via LED on
front panel.
Modbus Gateway from Modbus TCP to Modbus RTU: Ethernet / RS485 communication to remotely
control modules connected to the Modbus RTU ports with the possibility of setting RS485 ports in
Modbus master, Modbus slave mode.
Modbus TCP-IP / Modbus RTU bridge in real time.
Remote serial port (COM port) transparent to protocol.
Baud rate for Modbus RTU settable from 1200 to 115200 baud.
Firmware update via Web Server/ FTP Server / microSD card.
POSSIBLE CONFIGURATIONS
- BRIDGE FROM MODBUS TCP-IP TO MODBUS RTU
- GATEWAY FROM MODBUS TCP-IP TO MODBUS RTU (PORT 1 AND PORT 2 MODBUS MASTER)
- GATEWAY FROM MODBUS TCP-IP TO MODBUS RTU (1 PORT MASTER AND 1 PORT SLAVE)
- GATEWAY FROM MODBUS TCP-IP TO MODBUS RTU (2 PORT SLAVES)
- REMOTE SERIAL COM PORT