EN
43
Setting the end positions
4.5.1. Semi-automatic setup mode WITH relief
in operation: bottom position, top stop
When the movement is interrupted twice during operation, the system signalises that it is in
semi-automatic setup mode. The drive only finds the upper end position automatically.
Important: A limit stop is required for the upper end position (e.g. box awning)!
The lower end position must be approached first. From here, move to the upper limit stop
without interruption until the drive is automatically switched off.
Operation
with switch
Operation with
setting switch
Movement
E
1 s
Press and hold the E button of the setting
switch for 1 seconds. Both previously set end
positions are deleted.
Note: Can be omitted during the initial installa-
tion or after resetting to the factory settings.
or
E
STOP
STOP
Move the drive downwards to the required
lower end position using the UP or DOWN but-
ton.
STOP
STOP
From here, move to the upper stop without
interruption. The drive stops automatically.
This correctly sets the direction of rotation.
Perform a test run. The drive moves upwards
against the stop and is briefly relieved.
