Seluxit SLX Heartbeat, Руководство по установке, Страница: 14 / 15

Troubleshooting
- Problem: I didn’t finish the installation or the onboarding process was started
before I finished the installation.
- Action:
- Finish the installation and then restart the onboarding process from the
first step
- Problem: The status indicator on the AED has a red cross, meaning that the AED is
not functioning correctly.
- Action:
- Report the problem to the service company monitoring the AEDs
- Problem: No LEDs blink during the onboarding process.
- Action:
- Remove battery.
- Put the battery back in.
- Start the onboarding process from the first step.
- If that doesn’t work, replace the battery with a new battery.
- Start the onboarding process again.
- Problem: The Sensor Eye LED doesn’t stop blinking.
- Action:
- Make sure that the Sensor Eye is placed correctly. Adjust and start the
onboarding process again from the first step.
- Change the Sensor Eye with a new Sensor Eye, and start the onboarding
process again from the first step.
- Problem: GPS LED doesn’t stop blinking.
- Investigate:
- Place a mobile telephone in the AED cabinet, close the door and try to
ring to the phone. If you can do so, the mobile signal is okay.
- Action:
- If the mobile signal is okay
→
start the onboarding sequence again
from the first step.
- If the mobile signal isn’t okay
→
call the service company monitoring
the AEDs to report the problem.
- Problem: Cloud LED doesn’t stop blinking.
- Investigate:
- Does the GPS LED light up?
- Action:
SLX Heartbeat for Zoll AED Plus, Installation Guide (version 1.4, September 2020) 14 of 15