SP LINK | Using SP LINK
Doc #OI0003 Part #004122 Rev 04 2010
|
103
Service Settings
Certain readings within your SP PRO must be correctly configured at the time of the original setup. These
include the time and date, an approximation of the state of charge and that the current shunts are zeroed.
To ensure that various timed functions within the SP PRO, such as generator
run schedules, perform as expected it is important to have the correct date and
time recorded in your SP PRO. You have the option of automatically uploading
the time and date from your computer – including the facility to allow for an
offset if your computer is set to a different time zone to the area of installation –
or to manually set the time and date.
If you are adjusting the date manually click on the circle adjacent to MANUALLY
SET DATE / TIME and use the drop down menu to select the correct date. The
time can be set by clicking on the hour or minute section and use the up/down
arrows to adjust.
When you have completed adjustment click on
SET SP PRO TIME
to record the
change.
