LD600-12 Manual
Selectronic Australia
16
LD600-12 Specifications
Inverter Type
Microprocessor control circuit with PWM full bridge power
stage. True sine wave AC output
Current draw from Battery
Condition
Amperage
Demand Start SLEEP mode (average)
Inverter ON, with no Load
Maximum Continuous Load (600 Watt)
Half hour rating (800 Watt)
Surge rating (1500 Watt)
0.06 Amps
0.54 Amps
60Amps
≈
80Amps
≈
147 Amps
Inverter Power Ratings @ 25
º
C
Total Inverter output
Condition
Wattage @ 1.0pf
Current
Continuous
Half hour rating
Surge rating (5 seconds)
600 Watt
800 Watt
1500 Watt
2.4 Amps
≈
3.3Amps
≈
5.4 Amps
Demand Start
Type
Minimum Load to Start
Response Time
Pulsing AC
4 watts – 16 watts user adjustable
1 second maximum
Battery Voltage Range
Voltage
Low DC Volts Cut Out–10 second delay
Low DC Volts Cut In
High DC Volts Cut Out–Instantaneous
10 – 11.5 volts user adjustable
12 volt
17 volts
LD600-12 Manual
Selectronic Australia
1
Introduction
Thank you for choosing to purchase the Selectronic LD600-12 TRUE
SINE WAVE inverter. Many hours of Research and Development have
gone into the LD600-12 to ensure this inverter provides you with many
years of reliable service
Warranty Card
It is imperative that you complete your warranty card NOW. Your LD600-
12 is covered by a TWO year warranty; this warranty is in addition to your
rights under the trade practices act of your state or territory.
Returning you completed warranty card will enable us to register your
warranty and avoid any possible delays should service be required. If you
have any comments about our product that will not fit on the warranty card
please feel free to drop us a line. Yes, constructive criticism will also be
welcome.
Installation
200mm
200mm
200mm
LD600-12
Inverter
Front
200mm
LD600-12 Inverter
Please leave a clearance of 200mm on all sides and top of the Inverter.
The LD600-12 must be installed in a dry, cool and dust-free environment.
It is recommended that the inverter be placed as far from any radio
receivers as possible.