7
HOLD DOWN BRACKETS (OPTIONAL)
Optional hold down brackets are mounted with the supplied screws.
With the shade at its proper drop, place the pin in each end cap and mark the
screw holes.
Make sure the pins are level and aligned.
Raise the shade, then screw the hold down bracket into the mounting surface.
Flex the hold downs out to reinsert the bottom rail.
SKEW ADJUSTMENT (IF NECESSARY)
If the shade does not raise evenly, first make sure the mounting brackets are
mounted level with each other.
If the shade is level and it still skews, roll the shade all the way down. Prepare
a strip of masking tape approximately 5” long.
On the side of the shade opposite of the skewing direction, and as close to
the end of the roller as possible, apply the tape with the sticky side facing the
fabric. The tape should be placed on the back of the roller, out of sight.
Roll the shade up and check for skewing. If the shade is still skewing, add
another strip of tape on top of the first one. If the shade is now skewing in the
opposite direction, tear off about 1” of tape from the last strip installed.
Place tape at this end
