300W / 500W / 800W
HUI CYC, FLOOD and GROUNDROW range
THANK YOU FOR PURCHASING A SELECON
HUI
LUMINAIRE.
WE HAVE DESIGNED THIS LUMINAIRE TO PROVIDE YOU WITH A
SUPERIOR FITTING IN PERFORMANCE, DESIGN AND ENGINEERING.
WE ARE CONFIDENT THAT IT WILL PERFORM TO YOUR EXPECTATIONS
FOR MANY YEARS TO COME.
Before operating your new luminaire please read this information to assist you in
making maximum use of your luminaire, its maintenance and care. If you would like
further assistance contact your Selecon dealer or Selecon.
SAFETY – MAINS POWER ISOLATION
The
HUI
Cyc and Flood range is available fitted with two micro-switches which automatically disconnect the
mains power when the Colour Cassette is opened.
MOUNTING YOUR LUMINAIRE
A variety of mounting options are available for your
HUI
luminaire. Theatrical style hookclamps, TV style barrel
clamps and groundrow feet are available from your Selecon distributor.
A safety chain (Order Code: 20SC) MUST always be used when rigging luminaires on bars, ladders etc.
The safety chain is passed through the luminaire anchor point hole located at the top of the body side
panel and around the bar. Be careful to allow sufficient slack to allow the luminaire to be focused
freely. Selecon supply a safety chain with all theatrical / entertainment luminaires.
: The luminaire should be at least 1.0 metre away from the nearest object it is lighting.
: The unit should be 0.3m from any object.
LAMPS
Use only standard 118mm, 800W P2/11, 300W K9 or 500W K1 THD R7 double ended linear lamps. Use
only lamps from a quality manufacturer to ensure proper light output and distribution. The Hui is not
designed for other lamp types, using these will shorten colour filter life and void your warranty.
To re-lamp, undo the latch at the top of the luminaire, and fold the colour cassette down. Carefully remove the
old lamp and replace it with the new one. Take care not to touch the glass itself as the oil from your fingerprints
can cause premature lamp failure. After replacing the lamp, fold up the colour cassette and latch it to the
luminaire body.
ISOLATE ELECTRICALLY BEFORE RE-LAMPING THE LUMINAIRE.
Also be aware that the lamp or luminaire may still be hot, so exercise necessary caution to avoid burns.
Please note also that these luminaires are not suitable for mounting on a normally flammable surface.
Version 2: December 2008 © 2008 Selecon New Zealand Limited All Rights Reserved
