SEH ThinPrint, Руководство пользователя

Страница: 57 / 130

ThinPrint Settings
TPR User Manual 57
6.7 How to Use the ThinPrint Connection Service
The ThinPrint Connection Service sends print jobs via TCP/IP to
ThinPrint clients (i.e. the TPR) in masked networks (NAT).
The Connection Service manages the entire communication between
the ThinPrint server and the corresponding client. This allows the
connection via masked networks as well as the assignment of the
relevant print job to the respective end device.
To use this service, you must prepare the TPR. For each end device
that uses the Connection Service, you must store the client ID and
an authentication key in the database of the Connection Service.
You must also set these two values on the TPR.
Please note that you need a ThinPrint license for each client ID.
Proceed as follows:
1. Start the TPR Control Center.
2. Select
DEVICE – ThinPrint® .
3. Tick Connection Service .
4. Enter the relevant parameters; see: Table 13

57.
5. Click Save to confirm.

The settings are saved.
Table 13: Connection Service Parameters
Parameters Description
Connection Service Enables/disables the ThinPrint Connection Service.
Server name IP address or host name of the server on which the
Connection Service is installed.
The host name can only be used if a DNS server was
configured beforehand.
Port Defines the TCP port used by the TPR for
communicating with the Connection Service.
The port number 4001 is preset.