© 2021
Order #XXXXX
Locked layer contains
placeholder marks.
*
U-Channel
Transformer
1
1A
2
2A
3
3A
4
4A
Item
1,1A
2,2A
3,3A
4,4A
--
Qty.
1,1
1,1
1,1
2
1
Description
36” CEI152 Vertical Extrusion
36” CEI152 Vertical Extrusion
24” CEI152 Horizontal Extrusion
Base Plate
9” U-Channel
Steps:
1) Attach u-channel to horizontal [3].
See
U-Channel Connection
detail.
2) Assemble CEI152 extrusions together, flat on floor.
See CEI152 Frame Assembly sheet for instruction.
3) Attach base plates to [3], using bolts, washers, and
wing nuts then lift assembled frame upright.
4) Connect lighting cords and attach transformers then
set transformers into u-channels. See
Light to Light
Connection
&
Light to Transformer Connection
details.
5) Install SEG graphics to front and back of assembled frame.
Completed Assembly
+
+
+
-
-
-
to power
Lights
Male
Male
Female
Female
Transformer
96W / 4A / 24V
Light to Light Connection
Light to Transformer Connection
Maximum of 7 lights per transformer.
U-Channel
Bolt
Bolt
Horizontal Extrusion
V2
V2
Slide V2 connectors into top groove of horizontal
extrusion. Tighten set-screws to secure. Attach
U-Channel to connectors, using bolts.
U-Channel Attachment
Note: V2 connectors stay attached when packing.
*
SEG Graphic Installation
Corner A
Corner D
Corner B
Corner C
It is important to first insert
graphic into each alternate
corner, then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on
the tab to remove the fabric.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
MOD-1601 Double-Sided Lightbox
If you would like to tell us about your experience with your setup instructions please email us at
SETUP INSTRUCTIONS
