Sega TETRIS GIANT, Руководство пользователя

Страница: 131 / 214

122
TROUBLESHOOTING
CIRCUIT PROTECTOR
PROBLEMS CAUSE COUNTERMEASURES
It will not enter TEST
MODE.
Problem with switch. Replace the switch.
Problem with game board. Replace the game board. (See Chapter 16.)
Incorrect procedure used to
switch to TEST MODE.
Check the operating instructions. (See Chapter
9.)
The on-screen display is not
normal.
Improper adjustment of
projector position.
Adjust the position of the projector. (See 6-5.)
The screen is damaged or the
sheet is peeling.
Replace the screen. (See 15-2.)
The projector does not
project images.
Defective wiring between game
board and projector.
Check to make sure the connectors are
connected.
Projector overheat protection. If the power is turned on when the projector
is hot, it may take a while for the lamp to turn
on. It will take 5 minutes for the lamp to be
ready.
Projector lens cover is closed. Remove the lens cover.
Projector lamp life. Replace the lamp. (See Chapter 11.)
Problem with projector. Replace the projector.
Problem with game board. Replace the game board. (See Chapter 16.)
No response when the
START buttons on the
control panel and the left/
right buttons of the joystick
are pressed.
Problem with buttons. Replace the buttons. (See Chapter 13.)
The connector came off. Check to make sure the connectors are
connected.
The halogen lamp does not
turn on.
Halogen lamp life. Replace the halogen lamp. (See Chapter 12.)
The joystick generates input
without being touched.
Problem with centering
mechanism.
Replace the joystick unit.
Contact the office listed in this manual.
Problem with sensors.
The joystick does not
vibrate.
STICK SWING setting is OFF. Change the STICK SWING setting to ON. (See
9-3-4.)
Problem with motor and clutch. Replace the joystick unit.
Contact the office listed in this manual.
There is no input when the
joystick is tilted.
The connectors came off. Make sure the connectors are connected.
Problem with sensors. Replace the joystick unit.
Contact the office listed in this manual.
Functions due to the activation of bimetal. To restore the function, wait for approximately 1 minute or longer until
the bimetal cools off. (Press the button.)
15
CIRCUIT PROTECTOR