ON
1
2
3
4
5
6
7
8
9 10
I N S T R U C T I O N S
REMOTE 300
Model
14-R300
1 of 2
IN THE BOX
Make sure you have everything shown here.
NOTE:
The CR2032 battery comes pre-installed.
Remote 300
Visor Clip
Button 1
LED
Button 2
DIP Switches on Receiver 300
(default positions)
WHAT’S WHAT
The Remote 300 has two programmable buttons and
a status LED. Each button can be paired to a separate
receiver or the same receiver.
SETUP
1. On your 300-MHz receiver, set DIP switches to
desired positions.
NOTE:
For best results, we recommend using
the Security Brands Receiver 300 (14-REC300).
NOTE:
By default, both sets of DIP switches on
the Remote 300 are matched to the default DIP
switch positions of the Receiver 300 and other
300-MHz receivers. For security reasons, we
recommend using custom DIP switch positions.
NOTE:
Some DIP switches may be labeled
differently. The position labeled 10 corresponds
to the position labeled 0 on the remote, and
the DIP switches on some receivers have the off
position labeled as OPEN.
2. Open Remote 300 unit by removing two screws
on bottom side and pulling case apart. Remove
visor clip if needed for easier access.
NOTE:
Make sure the circuit board stays
attached to the base of the remote unit and
does not come off with the cover.
