© 2021 Security Brands, Inc. All rights reserved.
4 of 18
QSG-27240-EN Rev. A (2/2021)
Q U I C K S TA R T
G U I D E
Model
27-240
4a
4b
IMPORTANT
r
r
CAUTION
STOP
6
7
5
If you would like to use a third-party
power source such as solar, verify that it
conforms to the following specs:
Connect wires to unit as shown in
Step 4.
Connect wires to your power source,
making sure you connect positive to
positive and negative to negative.
Double check that you have wired from
positive on the Edge unit to positive on your
power source and negative on the Edge unit
to negative on your power source.
Reverse polarity can damage the unit!
Input
12–24 VAC/DC
no more than 10% beyond this range
Current Draw
less than 111 mA @ 12 VDC
less than 60 mA @ 24 VDC
Using a Third-Party
Power Source (Optional)
Before going forward, double check all
wiring and make sure the unit has power!
Wiring diagrams for connecting to accessory
devices can be found on
Pages 5 and 6
.
For connecting accessories not mentioned,
please contact
Technical Support
.
Make sure the gate or door path is clear
before completing Step 7!
Add Access Code to Relay A.
(To add multiple codes, enter each of them before pressing pound key.)
Make sure gate or door path is clear;
then enter access code on Pad,
and con
fi
rm gate or door opens.
Jump to
Page 7
to continue programming and
download the Edge Smart Keypad app.
INSTALLATION COMPLETE!
N
1
1
1
2
5
?
?
?
?
Access Code to Be Added
(4 digits by default; numbers only)
Master Code
(can be changed)
Sub Mode
Grab Programming Pad, making sure it
is connected to circuit board.
NOTE: The green arrow indicates a “good” tone on the Edge unit. By default, the following
codes are reserved and cannot be used: 1251, 1273, 1366, 1381, 1387, 1678, 1752, and 1985.
