Create and Configure the ETM® Database
31
Create and Configure the ETM
®
Database
Creating and configuring the database consists of the following sequence of
tasks:
1.
Install a supported DBMS and then run the Perl scripts to configure the
ETM Database for use by the ETM Server.
2.
Copy the correct database driver to the ETM Server installation
directory.
3.
(
Does not apply with Oracle 10g XE; the ETM Server must reside on
the same computer
.) If the database is on a different computer than the
ETM Server, install the Oracle client tools on the ETM Server
computer and then copy important database files from the database
computer to the ETM Server.
4.
Connect to the database with the ETM Database Maintenance Tool and
complete database configuration.
For information about supported Oracle versions, see the
Minimum System
and Network Requirements
on the SecureLogix Knowledge Base at
http://support.securelogix.com
Since the procedure for installing and
configuring the Oracle DBMS varies according to the operating system on
which it is to be installed and the version of Oracle to be used, those
instructions are not included in this installation guide. See the SecureLogix
Knowledge Base, or contact SecureLogix Customer Support.
The instruction document also describes the Oracle services the ETM
System requires, to ensure that an existing installation meets the
requirements.
After installing and configuring the database, if you have not already done
so, copy the Oracle driver file—
ojdbc14.jar
(10G) or
ojdbc6.jar
(11G)—
from
<ORACLE_HOME>\jdbc\lib
in your database installation to each
of the following ETM
®
System installation directories:
The ETM Server.
Any remote Report Server.
Any remote ETM Database Maintenance Tool.
Remote ETM System Clients and standalone Usage Managers do not
require the driver file.
Install and
Configure the
Oracle DBMS
and Database
Copy the Oracle
Database Driver
to the Required
Locations
