2.2
Technical Specifications
Processors
NXP i.MX6 Family, based on ARM
®
CORTEX-A9 processors
-
i.MX6S Solo - Single core up to 1GHz
-
i.MX6DL Dual Lite - Dual core up to 1GHz per core
Memory
Up to 1GB DDR3L onboard (up to 512MB with i.MX 6Solo)
Graphics
Dedicated 2D Hardware accelerator
Dedicated 3D Hardware accelerator, supports OpenGL
®
ES2.0 3D
Supports 2 independent displays
Video Interfaces
1 x LVDS Dual Channel or 2 x LVDS Single Channel 18/24 bit interface
HDMI Interface
Video Resolution
LVDS, resolution up to 1920x1200
HDMI, resolution up to 1080p
Mass Storage
Onboard eMMC Drive, up to 8 GB*
SD/MMC/SDIO interface
Internal SPI Flash for booting
PCI Express
1 x PCI-e x1 lane (only PCI-e 1.1 and Gen2 are supported)
* Please consider that for HDD and Flash Disk manufacturers, 1GB = 10^9 Byte.
Some OS (like, for example, Windows) intends 1GB = 1024^3 byte, so global
capacity shown for Disk Properties will be less than expected. Please also consider
that a portion of disk capacity will be used by internal Flash Controller for Disk
management, so final capacity will be lower.
Networking
FastEthernet (10/100 Mbps) interface
USB
1 x USB OTG interface
1 x USB2.0 Host interface
Audio
I2S / AC
’
97 Audio interface
Other Interfaces
On the card edge connector, many pins can be used as General Purpose I/Os or to
implement some (*) of the following extra functionalities:
-
Additional SD interface
-
Up to 4 UARTs
-
CAN interface
-
Watchdog(s)
-
I2C interfaces
-
PWM outputs
-
SPI interface
-
Additional Audio interface
(*) not all the combinations are allowed simultaneously
Power Management Signals
Power supply voltage: +5V
DC
± 5%
Optional Low Power RTC
Operating temperature: 0°C ÷ +60°C **
Dimensions: 40 x70 mm (1.57
”
x 2.76
”
)
** Temperatures indicated are the maximum temperature that the
heatspreader / heatsink can reach in any of its parts. This means that it is
customer
’
s responsibility to use any passive cooling solution along with an
application-dependent cooling system, capable to ensure that the
heatspreader / heatsink temperature remains in the range above indicated.
Please also check paragraph 4.1
