Seat Leon 2013, Руководство по ремонту

Страница: 134 / 279

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
14 - Oil drain plug
❑ renew
Note
Only renew at the first oil change
following the factory fitting.
⇒ page 129
❑ 30 Nm
15 - Suction pipe
16 - Bolt
❑ 8 Nm
17 - Bolt
❑ For tensioning assembly
❑ renew
❑ 20 Nm + 90°
18 - Oil seal
❑ Replace ⇒ page 46
❑ For oil pump drive
19 - Bolt
❑ renew
❑ Specified torques
⇒ page 136 .
20 - Oil pump
❑ Removing and installing ⇒ page 134
21 - Seal
❑ renew
❑ Note guide pins for proper positioning.
Sump - tightening torque and sequence
– Tighten bolts in stages in the sequence shown:
stage Bolts Tightening torque
1. -1 … 19- Screw in by hand until they make con‐
tact
2. -1 … 19- 8 Nm + 90°
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
128
Rep. gr.17 - Lubrication