1
Tools Required:
Phillip’s Head Screwdriver
7/16 Socket or Wrench
4MM Allen Wrench (Included)
(13) Adirondack Classic Swing rev. A
WOOD
ENVIRO
S
EASIDE
C
ASUAL
F
URNITURE
Hardware:
(6) 3-1/2” Connector Bolts
(2) 2-3/4” Connector Bolts
(5) 1-3/4” Phillip’s Head Screws
(8) Flat Washers
(8) Lock Washers
(8) Nuts
(2) Legs
(1) Seat Assembly
(2) Arms
Parts List:
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING!
Carefully remove contents
from box. Make sure that all parts and hardware are included.
Place Leg on side of Seat Assembly on top
of the Front Rope Support, while aligning
pre-drilled holes on both Legs and Seat As-
sembly, also make sure Arm Support al-
ready attached to leg face inside of the
swing (Left Picture). Attached Leg with (2)
3-1/2” connector bolts (Right Picture). Fin-
ger tighten flat & lock washers and nuts.
Do not tighten at this time. Repeat process
got other side.
Step Two: Leg Assembly
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Step Three: Back Assembly
Install the Back Assembly to the Seat As-
sembly aligning pre-drilled holes on both
assemblies together. Attach using (2) 1-
3/4” Phillips Head Screws (Left Picture).
Repeat process of other side. Attach middle
of the Back Assembly using (1) 1-3/4”
Phillips Head Screw (Right Picture).
(1) Back Assembly
(2) Rope
Instruction Revision: A
