
Repair
VB.
Water valves
Access the water valve from the front of the dishwasher base by removing the
toe kick.
To remove water valve
Tools needed: T20 Torx screwdriver, wrench & pliers
.
1.
Remove toe kick
– see section VA.
2. Disconnect water line.
3. Remove two T-20 Torx screws from water valve.
4. Pull valve out from dishwasher and disconnect terminal connector,
ground wire and water hose from rear of valve. Remove any water from
sump & base.
Connection hints:
Water connection 3/8” NPT female. Inlet water pressure range 5 - 120 psi
(0.3 – 8.27 bars).
When reconnecting the water supply to the water valve, don’t overtighten the
elbow fitting. The plastic in the valve may crack and cause leaking if
excessive force is used.
Using Teflon tape on water fittings can help prevent leaking.
VC.
Controls
Fascia panel mounted controls
Controls are easily removed from fascia panels by gently bending plastic tabs.
Tools needed: T-20 Torx & flat blade screwdrivers
.
1.
Remove fascia panel
– see section VA.
2. Disconnect wire harnesses from control after noting connector locations.
702_58300000150187_ara_en_a
3. Carefully pry back plastic tabs, then slide control from fascia panel. Start
prying clips from one side and gently lift control as you pry clips from one
side to the other.