Sears CRAFTSMAN C950-52871-0, Руководство пользователя

Страница: 13 / 120

ASSEMBLY
13
Figure 8
Assemble Remote Deflector Cable
2. Attach rod (B) to deflector post.
1. Slide compression spring (A, Figure 8) over rod and
insert into hole on chute deflector bracket.
3. Attach remote deflector cable (C) to deflector post.
Secure with push nut (D).
NOTE: Before completing Step 4, make sure that the
chute deflector is in the full open position.
4. Route remote deflector cable (C) through slot in chute
deflector bracket. Secure with nuts (E) and washers
on either side of bracket.
5. Check remote deflector chute for proper operation.
Make adjustments as necessary.
SNOW CHUTE ASSEMBLY
NOTE: The chute ring assembly (A) comes installed
on the unit from the factory (see Figure 7).
NOTE: Make sure the notch in the chute ring aligns
with the arrow on the outer ring.
1. Install chute deflector (B, Figure 7) using four
four screws (C) and nuts (D) in holes as shown.
The chute deflector must point forward for proper
installation.
2. Tighten screws snugly but be careful not to
over-tighten.
Assemble Chute Deflector
Figure 7
A
B
C
D
B
A
D
C
E
F
Not
for
Reproduction