Not for
Reproduction
TROUBLE SHOOTING CHART
38
1741633
PROBLEM
LOOK FOR
REMEDY
Difficult starting
Defective spark plug.
Replace defective spark plug.
Engine runs erratically
Blocked fuel line.
Clean fuel line.
Empty gas tank.
Check fuel supply,
Stale gasoline.
Add fresh gasoline with fuel stabilizer.
Water or dirt in fuel system.
Remove carburetor bowl to drain fuel tank. Refill
with fresh fuel.
CAUTION: Do not remove
carburetor bowl when the engine is hot.
Engine stalls
Unit running on CHOKE.
Set choke lever to RUN position.
Loss of power
Gas cap vent hole is plugged.
Remove ice and snow from cap. Be sure vent
hole is clear.
Excessive vibration
Loose parts or damaged impeller.
Stop engine immediately and remove spark plug
wire. Tighten all bolts and make all necessary
repairs. If vibration continues, have the unit
serviced by a competent repairman.
Unit fails to propel
itself
Drive belt loose or damaged.
Replace drive belt. Refer to
Drive Belt
Replacement
in
Adjustments/Repairs
section of
this manual.
Incorrect adjustment of traction drive
cable.
Adjust traction drive cable. Refer to
Cable
Adjustment
in
Adjustments/Repairs
section of
this manual.
Worn or damaged friction disc.
Replace friction disc. Refer to
Friction Wheel
Replacement
in
Adjustments/Repairs
section of
this manual.
Unit fails to discharge
snow
Auger drive belt loose or damaged.
Replace or adjust auger drive belt. Refer to
Drive
Belt Replacement
and
Drive Belt Adjustment
in
Adjustments/Repairs
section of this manual.
Auger control cable not adjusted
correctly.
Adjust auger control cable. Refer to
Cable
Adjustment
in
Adjustments/Repairs
section of
this manual.
Broken shear bolt.
Replace shear bolt. Refer to
Auger Shear Bolt
Replacement
in
Adjustments/Repairs
section of
this manual.
Discharge chute clogged.
Stop engine immediately and disconnect spark
plug wire. Refer to the first
Warning
in
Snow
blower Operation
in
Operation
section of this
manual. Clean discharge chute and inside of
auger housing.
Foreign object lodged in auger.
Stop engine immediately and disconnect spark
plug wire. Refer to the
third Warning
in
Snow
blower Operation
in
Operation
section of this
manual. Remove object from auger.
Identifying Your Snow blower
Your new Snow blower has two (2) identifying numbers: (1) unit model number: (2) unit serial number. The two preceding
numbers are required to insure that the proper replacement parts are obtained when required. If you have any questions
concerning parts, service, or technical data, contact your nearest Sears Service Department.
For complete warranty information refer to the warranty in the Owner’s Information section of this manual.
Содержание Craftsman C950-52721-0
