background image

2

CONTENTS

INTRODUCTION/WARRANTY .........................................2

SAFETY ..............................................................................2

INSTALLATION...............................................................3-4

OPERATION ......................................................................4

MAINTENANCE ..............................................................4-5

PARTS ................................................................................5

INTRODUCTION

Please read our instructions before you install and use your
new pump; this will help you obtain full value and good ser-
vice from it. It will also help you avoid needless service costs
that result from causes we cannot control and cannot cover
in our warranty.

READ AND FOLLOW

SAFETY INSTRUCTIONS!

Carefully read and follow all safety instructions in
this manual or on pump.

This is the safety alert symbol.

When you see this

symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for per-
sonal injury!

warns about hazards that 

will 

cause serious

personal injury, death or major property damage if ignored.

warns about hazards that 

will 

or 

can 

cause se-

rious personal injury, death or major property damage if 
ignored.

warns about hazards that 

will 

or 

can 

cause

minor personal injury or property damage if ignored.

The word 

NOTICE 

indicates special instructions which are

important but not related to hazards.

1. To avoid risk of serious bodily injury and property dam-

age, read safety instructions carefully before installing
pump.

2. Follow local and/or national plumbing and electrical

codes when installing pump.

Use this pump only on a 115 volt circuit.

Pump is equipped with an approved 
3-conductor cord and 3-prong, grounding-

type plug. To reduce the risk of electric shock, con-
nect it to a properly grounded, grounding-type
receptacle.

Do not operate the pump continuouisly at a discharge
pressure of more than 12 psi (83 kPa) or discharge lift of
more than 28’ (8.5 M), as the motor will exceed the nor-
mal safe operating temperature and may heat to 180° -
190° F (82° C - 88° C).

INSPECTION

This pump was thoroughly inspected, tested, and packaged
before shipment. Report any damage immediately to the
store where it was purchased.  

Hazardous
voltage

Discharge Height in Feet Above Pumping Level

Model

3

10

15

20

30

40

390.269152

5.5

5.0

4.6

4.0

2.5

1.0 

}

GPM

PERFORMANCE

ONE YEAR FULL WARRANTY

Provided that it is installed and operated according to the owner’s manual instructions, if this pump fails due to a
defect in material or workmanship within one year from the date of purchase, it will be replaced or repaired free
of charge.

Warranty service is available by returning this product to place of purchase for replacement, or by calling 
1-800-4-MY-HOME

®

to arrange for repair.

This warranty is VOID if this pump is used for commercial or rental purposes.

Sears is not liable for loss or damage to property, nor for any incidental or consequential loss or expense from
property  damage, that results directly or indirectly from the use of this product.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Sears Roebuck and Co., Dept. 817WA, Hoffman Estates, IL 60179

Содержание CRAFTSMAN 390.269152









Отзывы: