Sears C 151 61822 4, Руководство пользователя

Страница: 29 / 48

27
* Please refer to parts breakdown section in subframe manual for parts identification .
PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION
The shackle between the
accessory and the lifting
pulley is broken or the back
of
the snowblower is
deformed.
Excessive repeated impacts. Replace shackle and / or straighten the
back of the snowblower. After repairs,
drive slowly crossing obstacles, to avoid
putting excessive tension on the
shackle.
Excessive high lifting overload.Lifting
too high when snowblower is covered in
snow. Replace shackle and / or straighten the
back of the snowblower. After repairs,
take care to lift the snowblower when it
is free to move (not covered in ice, ...),
and not covered with snow.
The shackle between the
accessory and the pulley lift
is slightly distorted.
Impacts Use shackle as it is, if you need to
replace the cable or remove the pulley,
remove the bolt from the pulley.
Drive slowly over obstacles.
Lifting when overloaded with snow. Use shackle as it is, if you need to
replace the cable or remove the pulley,
remove the bolt from the pulley.
Be sure to lift the snowblower when it is
free to move (not covered in ice, ...) and
not covered with snow.
Limit switch broken Use shackle as it is, if you need to
replace the cable or remove the pulley,
remove the bolt from the pulley.
See the troubleshooting section for this
problem on the next page.
Cable wound up in reverse, therefore
the limit switch did not stop the winch
when lifting procedure was complete. Use shackle as it is, if you need to
replace the cable or remove the pulley,
remove the bolt from the pulley.
See the troubleshooting section for this
problem on the next page.
MAINTENANCE
TROUBLESHOOTING