INSTRUCTIONS FOR
SAC CLUTCH ALIGNMENT TOOL
MODEL NO:
VS011A.V3
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
R
WARNING!
Wear approved eye protection. Wear appropriate Personal Protective Equipment. A full range of Personal Protective
Equipment is available from your Sealey dealer.
R
WARNING!
Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to
when using tools.
DO NOT
use tools if damaged.
Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
Ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
Wear suitable clothing to avoid snagging.
DO NOT
wear jewellery. Tie back long hair.
Account for all tools, parts and components being used.
DO NOT
leave these in or near the engine. Return tools to suitable storage
after use.
These Instructions are provided as a guide only.
Always refer to the vehicle manufactures’ service instructions or a proprietary manual to establish the correct procedure and data.
R
WARNING!
The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The Operator/
user must apply caution and common sense (good practical sense).
2. INTRODUCTION
Necessary for pre-tensioning self adjusting clutches before removal or installation. Prevents plate distortion which may prevent the clutch from
disengaging or cause dragging. Features a refitting tool, allowing the clutch adjuster to be wound back. Also includes a selection of clutch plate
and spigot alignment adaptors. Supplied in carry-case.
3. SPECIFICATION
Model no: VS011A
Clutch plate adaptors:
17.9, 18.9, 19.9, 20.9, 21.9, 22.9, 23, 25.9, 27.9, 31.9, 33.9mm
Spigot adaptors:
13.9, 14.9, 15.9, 16.9, 17.9, 18.9, 20.9, 21.9mm
A
ssembly flywheel threads:
Ø6x1, Ø7x1, Ø8x1.25mm
4. CONTENTS
Refer to
instruction
manual
Wear eye
protection
Item Part No.
Description
Qty
1
VS011A.V3-32 Adaptor stud M6x1.0 silver
4
2
VS011A.V3-33 Adaptor stud M7x1.0 silver
4
3
VS011A.V3-30 Adaptor stud M6x1.0 gold (knurled)
4
4
VS011A.V3-33 Adaptor stud M7x1.0 silver (knurled)
4
5
VS011A.V3-31 Adaptor stud M8x1.25 black (knurled)
4
VS011A.V3 | Issue 1 19/05/15
Original Language Version
© Jack Sealey Limited
fig.1
