Anemometer
Model no:
tA070
thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAfety
WArnInG!
ensure Health & Safety, local authority and general workshop practice requirements are adhered to when using this
equipment.
WArnInG!
this equipment can be used in a wide variety of conditions and situations including workshop, industrial
and marine environments.
In each case, the user of the equipment must familiarise themselves with the safety regulations that
apply to the particular conditions or situation in which the equipment will be used and do their own risk assessment in order to stay safe
and avoid personal injury.
9
Maintain correct balance and footing. ensure the floor is not slippery and wear non-slip footwear.
9
Keep the anemometer clean and in good condition.
9
Protect the anemometer from solvents, acids or other aggressive substances.
9
Keep children and unauthorised persons away from the work area.
8
Do not
get the anemometer wet or use in damp or wet locations or areas where there is condensation.
8
Do not
use the anemometer for any purpose other than that for which it is designed.
8
Do not
use the anemometer if any part of it is damaged.
8
Do not
allow untrained persons to use the anemometer.
8
Do not
use the anemometer when you are tired or under the influence of alcohol, drugs or intoxicating medication.
9
When not in use, clean the anemometer and store in a safe, dry, childproof area.
WArnInG! the warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but
must be applied by the operator.
2. IntroDuctIon
Wind speed measuring device featuring live/max/average/wind chill and Beaufort scale. Ideal for checking workshop dust/fume extraction
devices. Also reads temperature which can be measured in either °C or °F. Readings are displayed on a 24mm high back-lit lCd screen.
Features a battery indicator and auto/manual power off.
3. SpecIfIcAtIon
Model no: ....................................................................TA070
Battery: ............................................... CR2032 3V (supplied)
nett Weight: ................................................................0.07Kg
4. operAtIon
4.1.
Switch on procedure
4.1.1.
Hold down the MODE button (fig1.1) for 2 seconds.
The unit will display the Air Velocity, Temperature and Battery
Condition. The screen backlight will illuminate for 12
seconds.
4.2.
Setting the unit of measurement (Air Velocity)
4.2.1.
With the unit switched on, hold down the Mode button
(fig.1.1) for 3 seconds until the ‘m/s’ symbol on the
display screen (fig.2) starts to flash.
4.2.2.
Press the SET button (fig.1.2) to scroll down to the desired
unit of measurement on the display screen (fig.2).
4.2.3.
once the desired unit of measurement for air velocity has
been selected, press the MODE button (fig.1.1) to confirm the
selection.
TA070 Issue 2 (HF) 17/05/18
Original Language Version
© Jack Sealey limited
Refer to
instructions
