4.2
refer to fig.2.
4.2.1 slide the wheel frames (15) over the axle, ensure the bush
housing is facing inwards.
4.2.2 secure with support rod (19) and M6x40 hex bolts (2).
4.3
refer to fig.3.
4.3.1 take the hopper (13) and lay it upside down, lower the gearbox
and frame onto the hopper, inserting the vertical axle through
the hopper.
4.3.2 on top of the wheel frame lay the support leg (16), secure
together with hex bolts M6x70 (1) with large washer (6),
Inserting from inside the hopper securing with lock nuts (7) on
the outside.
fig.2
fig.3
fig.4
4.4
refer to fig.4.
4.4.1 slide the inner axle bushes (11) over the axle and push into the
frame. Ensure a tight fit.
4.4.2 Put on the wheels (18). secure the right hand wheel using hex
bolt M5x45 (3) and a lock nut (8).
4.4.3 After the wheel place a flat washer (5) over the end of the axle
and then the axle caps (9). use a soft faced mallet to ensure
the axle are seated correctly.
fig.4
Original Language Version
sPB37W Issue: 1 - 21/06/11
note!
Before assembly ensure there are no missing parts or fixtures.
4.1
refer to fig.1.
4.1.1 slide the Impeller (14) over the vertical axle on the gearbox (12).
4.1.2 secure the Impeller to the axle with a round head bolt M4x20 (4).
Ensure the impeller is secured to the lower hole on the axle.
fig.1
4. asseMblY
