PREMIER ENGINE CRANE 3TONNE - FIXED
MODEL NO:
PFC301
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Keep crane, lifting slings, support and beams in good working order and condition. Take immediate action to repair or replace damaged
parts by contacting your supplier. Ensure that all accessory lifting devices are suitably certified.
WARNING!
If crane is damaged, remove from service immediately.
9
Ensure the surface on which the crane is used is level, firm and capable of supporting the weight of the crane with maximum load - we
recommend concrete. Never use the crane on tarmacadam or other soft surfaces.
9
Keep children and unauthorised persons away from the working area.
9
Keep working area clean and tidy, free from unrelated materials and ensure that there is adequate lighting.
9
Ensure that load does not exceed the maximum lifting capacity of the crane. Overloading the crane is dangerous. Where appropriate, use
only the lifting points recommended by the manufacturer of the item to be lifted, e.g. vehicle engine.
9
Before lifting the load ensure that the crane jib is in the lowest practical position, that there are no obstacles which may snag the load
whilst it is being lifted and that the area above the jib is clear.
9
To avoid injury, be fully aware of your own and other persons locations in relation to the lifting and lowering, of the load.
9
Keep a sound footing and balance, and ensure the floor is not slippery.
9
Ensure jib extension is locked in position before lifting.
9
Ensure the center of gravity always remains inside the crane base.
8
DO NOT
harness the load at an angle or use any attachments not verified as fit for purpose.
8
DO NOT
allow the load to swing during lifting.
8
DO NOT
allow the load to drop suddenly. Lower load with care, ensuring that you are fully aware of the condition of the surface onto
which the load is to be placed.
8
DO NOT
load crane beyond its rated capacity for each specified jib extension position
as indicated on the adhesive label.
The capacity of
the crane reduces as the jib is extended.
8
DO NOT
position any part of your body beneath the load.
8
DO NOT
use the crane to move or transport a load other than for repositioning. The crane is a lifting device only.
8
DO NOT
apply any sideways pressure to any part of the crane during lifting or when a load is suspended.
8
DO NOT
attempt to adjust the safety valve, which has been set and sealed by the manufacturer.
8
DO NOT
use this product to perform a task for which it is not designed.
8
DO NOT
use whilst under the influence of drugs, alcohol or intoxicating medication.
8
DO NOT
climb on the crane.
9
When not in use fold the crane down and store in a safe, dry, childproof area.
9
This crane is designed for lifting within a garage or workshop environment.
WARNING!
Failure to heed safety and warning instructions may result in damage and/or personal injury and will invalidate the warranty.
2. INTRODUCTION
P
rofessional 3tonne fixed crane with parallel legs, designed to accommodate a standard size pallet and features heavy duty forged hook.
Lowers rapidly with no load, whilst providing smooth, controlled lowering under load conditions. Rear swivel wheels and handle make
manoeuvring the crane a simple operation. Beam can be set in four positions, with a capacity of 2000kg at its full extension of 1870mm. Crane
features two pumps one for slow, safe controlled lifting and a quick lift pump. Weighs 299kg and is suitable for workshop use.
PFC301 Issue: 2(F) - 31/10/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing
